GoPro Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi,

I have build a DIY mini USB (charger) cable for the GoPro Hero 3 BE which fits into the diving housing without modification. You can see the cable and some tests here:

You need a good USB cable and a male mini USB connector (and a lot patience for soldering).

greetings
 

·
Registered
Joined
·
51 Posts
its a good idea, however, i

its a good idea, however, i would opt for drilling through the casing to run the wires and put necessary gromits for waterproofing, rather than slamming them up against the rubber and door for waterproofing. Id think that there could be the chance that it might leak.
 
1 - 2 of 2 Posts
Top